S-Dizayn Fiat Egea Cross Chrome Door Handle 8 Pcs. 2020 Onwards Vehicle-Specific Chrome AccessoryProduct Features:Chrome products are produced with a mold system specifically for the part on the vehicle where they will be applied.Chrome products are produced from Class A 304 quality stainless steel.The products are shipped ready for installation with the high quality double-sided acrylic tape on the back.
Warranty: Stainless steel bright chrome products; It is covered by a 5-year warranty against rust.
Assembly Instruction: Install in a dry and dust-free environment. After removing the product from its packaging, be sure to perform assembly exercises on the area where it will be applied without removing the protective surface of the double-sided tape. Clean the surface to which the product will be attached thoroughly with a cleaning liquid (alcohol, spirit, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as perfumed cologne, wet wipes, gasoline, etc.) Cleaning the floor is very important for installation. Plastic parts with an oily and shiny surface, such as glass seals and door protection strips, need to be cleaned until this surface disappears. If the product contains an adhesive strengthening "Primer" wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot / should not be used on the painted surfaces of the vehicle). Apply it to the cleaned surface only to the area where the tapes on the back of the product will stick and the product will cover it. (Be careful not to apply it to parts where the product will not stick/cover) In order for the double-sided tape on the back of the product to show its full properties, the ambient temperature must be above 25°C. After removing the protective surface of the tape, use a hair dryer etc. to increase the adhesion force. Apply heat to the tape using the help of . Remove the protective surface of the tape on the back of the product and apply the product at once to the cleaned and, if necessary, primed area after applying heat. Make sure it adheres well by applying pressure with a dry cloth. In order for the product to adhere firmly, protect it from water for 24 hours and be careful not to wash your vehicle with pressurized water for 48 hours.
