S-Dizayn Fiat Grande Punto Door Protection Strip Chrome 2006-2018Note: Front Trim 100 cm, Rear Trim 60 cm
Chrome + ABS Plastic Door Protection Strip 8 Pieces (The product is sent in 4 pieces by combining the bottom-filled ABS plastic strip and chrome strips.) The product provides protection against damage to the door of your vehicle when opening the door in parking areas and near the wall. It is applied to the flat section on the side door of your vehicle. Read the assembly instructions in the description.
Product Features: Chrome products are produced from class A304 quality stainless steel. The products are sent ready for assembly with the high quality double-sided acrylic tape on the back. (The product is sent in 4 pieces by combining the bottom-filled ABS plastic lath and chrome laths.)
Warranty: Stainless steel bright chrome products are covered by a 5-year warranty against rust. Installation Instruction:
Install in a dry and dust-free environment. After removing the product from its packaging, without removing the protective surface of the double-sided tape on it, an installation exercise is carried out in the middle of the doors, leaving a gap of 2-3 mm from the middle of the door, so as not to prevent the doors from opening and closing. The suitability of the middle part of the product is checked by opening and closing the rear door. Clean the surface on which the product will be adhered thoroughly with a clean cloth (Do not clean with liquids containing additives such as perfumed cologne, wet wipes, gasoline, etc.). The cleanliness of the floor is very important for installation. The product is double-sided on the back. For the tape to show its full properties, the ambient temperature must be above 25°C. After removing the protective surface of the tape, use a hair dryer etc. to increase the adhesion strength. Apply heat to the tape using the help of . Remove the protective surface of the tape on the back of the product, apply heat and then stick it in one go. Make sure it adheres well by applying pressure with a dry cloth. In order for the product to adhere firmly, protect your vehicle from water for 24 hours and be careful not to wash it with pressurized water for 48 hours.
