Vehicle-Specific Abs Chrome Accessory
Product features:
Chrome products are produced with a mold system specifically for the part on the vehicle where they will be applied.
ABS chrome products are produced as chrome plated on ABS plastic.
The products are shipped ready for installation with high quality double-sided acrylic tape on the back. (Reinforcing silicone application can be applied to wide products).
Guarantee:
ABS chrome plated products; Chrome plating is covered by a 1-year warranty.
Assembly Instruction:
Install in a dry and dust-free environment.
After removing the product from its packaging, practice the installation in the area where it will be applied without removing the protective surface of the double-sided tape.
Thoroughly clean the surface on which the product will be adhered with a cleaning liquid (alcohol, rubbing alcohol, cellulosic thinner, etc.). (Do not clean with liquids containing additives such as perfumed cologne, wet wipes, gasoline, etc.) Cleaning the floor is very important for installation. Plastic parts with an oily and shiny surface, such as glass seals and door protection strips, must be cleaned until this surface disappears.
If the product contains an adhesive strengthening "Primer" wipe (Primer: It is a chemical liquid to be applied to plastic surfaces. It cannot/should not be used on painted surfaces of the vehicle), apply it to the cleaned surface only to the product. area where the tapes on the back of the product will stick and the product will cover. (Be careful not to apply it to parts where the product will not stick/cover)
The ambient temperature must be above 25°C for the double-sided tape on the back of the product to show its full properties. After removing the protective surface of the tape, use a hair dryer etc. to increase the adhesion strength. Apply heat to the band using
After removing the protective surface of the tape on the back of the product and applying heat, apply the product to the cleaned and, if necessary, primed area at once. Make sure it adheres well by applying pressure with a dry cloth. In order for the product to adhere firmly, protect it from water for 24 hours and be careful not to wash your vehicle with pressurized water for 48 hours.
